保定电气厂

主要用于电流互感器二次侧由于各种异常引起的过电压保护。该保护器并接于电流互感器二次绕组的两端，正常运行时泄露电流极小，呈高阻状态。由于漏电流极小（小于1mA），对该回路保护动作值和表计准确精度的影响可以忽略不计。此时保护器控制电路不工作。

It is mainly used for the over voltage protection of the two side of the current transformer due to various anomalies. The protector is connected to the two ends of the two winding of the current transformer, and the leakage current is very small in normal operation and is in a high resistance state. Because the leakage current is small (less than 1mA), the effect on the protection action value of the circuit and the accuracy of the meter can be ignored. The protector control circuit does not work at this time.

当电流互感器二次回路开路或一次侧绕组出现异常过流时，在二次绕组中产生的电压高于正常运行电压，（其数值取决于电流互感器本身参数和运行工况）益护CTBZ系列保护器能在过电压产生时有效地被限制在50ns内，从而彻底避免了过电压危害并可靠地将二次绕组短路并发光提示，同时提供一组闭锁差动遥信接点。故障排除后，将其复位即可重复使用，动作寿命可达万次之多。避免了保护动作后更换保护器的麻烦，运行更加方便。

When the two circuit of current transformer primary winding open circuit or abnormal overcurrent, the voltage generated in the two winding of the higher than normal operating voltage (its value depends on the current transformer parameters and operating conditions) benefit support CTBZ series protector in overvoltage effectively is limited to 50ns thus, completely avoid the overvoltage and reliable two secondary winding short circuit and light tips, while providing a set of differential locking telesignalling contact. After the troubleshooting, the reposition can be reused, and the operation life can reach more than ten thousand times. The trouble of replacing the protector after the protection is avoided, and the operation is more convenient.